Ayra TDC 4 LED Manuel d'utilisateur télécharger pdf (Page 6)

Replacing or removing the gobos

The Ayra TDC Gobo Rainbow is equipped with 6 lenses, each provided with a separate LED source and a

gobo. A gobo is a certain pattern, which shapes the beam output in a certain pattern. It is possible to replace

the gobos of the TDC Rainbow, for example with your own company logo, a certain message, or specific

figures.

The gobos can be replaced by using the following dimensions:

Inner diameter (visible): 12 mm

Outer diameter: 20 mm

To replace or remove the gobos, please follow the instructions as shown below:

- Turn the fixture upside-down and place it on a soft surface to prevent scratches.

- Use your fingers to loosen the round knobs, used to hold the gobo-holder in place. Do this for all holders (if

needed).

- NOTE: Do not touch the lens in front of the gobo, as fingerprints and dirt may alter the light-output.

- Place the gobo holder in your hand (or on the table) with the lens faced down.

- Remove the inner ring by pushing the angled wire to the center with a small screwdriver. Do not apply too

much force, as the ring might jump away when under too much pressure.

- When the ring is detached, place your hand on top of the gobo and flip the holder over. The gobo will fall

onto your hand.

- Replace the gobo with another gobo, if preferred. If the gobos aren’t used, keep them in a small container

so they won’t get lost. Also store the metal rings in there, when not used.

- Mount all the parts back in reverse. Please note that the black, non-reflective side of the gobo always faces

the LED engine and the reflective side should be seen from the other side of the gobo-holder lens.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Ayra TDC 4 LED Manuel d'utilisateur Page 6